Never use Gocap to decide your dose amount. Always follow your doctor’s instructions.
Place the end of the insulin pen that you normally place a needle onto inside of the Gocap. When you have placed the pen on the Gocap correctly, you will still be able to see the dial at the other end of the pen.
The Gocap displays the mentioned values within 10 seconds.
The Gocap can display up to three checkmarks at once. New checkmarks are added from the right side of the display and existing checkmarks are shifted over one place. Each checkmark and circle will remain on the display for 10 hours from when it was added. If you log two doses within an hour, only one checkmark will be displayed for both doses.
If the Gocap has been added to the app and you are logging a dose for the first time, a “New pen” entry will appear on the Logbook. “New pen” will also appear anytime an insulin pen is inserted into the Gocap with a higher insulin amount than the previous insulin pen that was inserted or appears after a dose was not logged correctly on the Gocap. Tapping on the “New pen” entry allows you add the dose amount. D1
First – remove the pen, then repeat step 3.
If the Gocap has been added to the app, an “Unread dose” will appear on the Logbook. If another dose is logged correctly after the”Unread dose”, the next entry will appear as a “New pen” since the last dose amount was not known. Tapping on the “New pen” and “Unread dose” entry allows you to add the dose amount. E1
The Gocap website requires cookies to be enabled in order to power the shopping cart. Please enable cookies in your browser and refresh the page.